Genuine Mopar Passenger Side Rear Bed Outlet Kit 115 Volt

ATTENTION! IMPORTANT FITMENT REQUIREMENTS: 

• The Factory Power Inverter Option is REQUIRED for compatibility.
• A Factory Inverter Switch Harness Connector is also REQUIRED for compatibility. Prior to placing your order, please confirm that your vehicle is equipped with the inverter switch harness connector, as it is not present on all Gladiators.
• If present, the connector will be located behind the dash panel, directly where the inverter switch mounts. For a reference image of the required connector, please click here.

OEM Jeep Gladiator 115 Volt Bed Outlet Kit (For 2024 And Newer Models):

• Add the convenience of the factory option 115 volt / 400 watt outlet to your Gladiator's bed with this original equipment (OE) kit.
• Outlet is located within the bed at the right (passenger side) rear location next to the tailgate.
• Same as the production option. Please read all application and fitment details to confirm fitment for your vehicle.
• Replaces Part Number: 68312754AB
• For installation instructions, please click here.

Bed Plug Kit Contents:

• Inverter Switch - 68370049AA
• Jumper Wiring - 68616398AB
• Inverter Power Outlet - 68312754AC
• Tapping Pan Head Screw And Washers - 6104610AA (x4)
• Plastic Nuts - 6509748AA (x4)

PLEASE NOTE:

• Programming is required via a 3rd party programmer such as Z Automotive Tazer or J-scan.  Not Included.
• This kit is NOT applicable to (2020-2023) vehicles due to a change in the required wire harness. Please use Part Number BEDOUTLETKITJT20 instead.
• Wire harness shown in product image is for reference only and shows a generic Jeep wire harness. Products are not shown to scale.